fpi2002 serial help

Hi guys, I hope this list is still open considering
all the spam I noticed on it.

I'm running Kubuntu Dapper 6.06 right now on my
Tc1000, and I've been struggling to get the pen
support to work all day now. I got the proper
linux headers, and compiled it correctly
(as far as I can tell), however when after I load
the module (modprobe fpi2002) and I bust a

# setserial /dev/ttys0 autoconfig

I get an "input/output error" on that device. I've tried
adding the module to /etc/modules at the top of the
list so it loads before any other serial devices (heard
order matters sometimes) but it hasn't changed anything.

whats wierd is at one point I did recieve this after the setserial command:

/dev/ttyS0, UART: unknown, Port: 0×03f8, IRQ: 4

which as far as I can tell means I was close. I just needed
it to ID UART as 16550A. However I never could get it to
do so and I havne't even gotten that far since. All I can get
is " /dev/ttys0: Input/output error". Any thoughts?

Thanks,

Tyler
Received on Sun Oct 15 2006 - 00:20:41 EDT