Re: rx3115 not working

Hi. Thanks for your response.

On 2/3/07, Warren Crossing <warren.crossing_at_mofokom.biz> wrote:
> so HarET, unloads wince shows the pengiun and then the pengiuns eyes
> explodes and starts the kernel.
> does the screen pixelates into a rainbow of colored ants?

yes

> do you see any text from the kernel?

Not a single line. After the screen fills with "colored ants" nothing happens.

> If so can you give the last few
> lines of text? Thanks. Also can you see where the kernel detects the
> mmc? it should show the partitions <mmcblk0p1><mmcblk0p2> etc.. make
> sure you have the correct root in your default.txt
> set CMDLINE "root=/dev/mmcblk0p1"

It simply can't get to the rootfs mount stage.

>
> hope this helps
>

Unfortunately not, but thanks for your time.

Fabio

> Fabio Comolli wrote:
> > Hi all.
> > I can't make linux run on my rx3115. Steps I followed:
> >
> > * downloaded
> > http://morgan.fbi.cz/pub/rx3715/gpe/30-nov-06/gpe-rx3715-0.8.4.tar.bz2
> > * extracted wince-loader into internal memory
> > * extracted sd-image into an empty mmc card formatted with FAT
> > * run haret
> >
> > I can see the penguin image and the bar on the right. At the end of
> > the download the screen messes up and stays so.
> >
> > It seems that the kernel crashes during load.
> >
> > Any ideas? I don't know if it can be important, but I have latest
> > firmware installed (1.01.11).
> >
> > Best regards,
> > Fabio
> >
> > (Please keep me in CC:)
> > _______________________________________________
> > Rx3700-port mailing list
> > Rx3700-port_at_handhelds.org
> > https://www.handhelds.org/mailman/listinfo/rx3700-port
>
>
>
Received on Sat Feb 03 2007 - 08:59:41 EST