Re: rx3115 not working

so HarET, unloads wince shows the pengiun and then the pengiuns eyes
explodes and starts the kernel.
does the screen pixelates into a rainbow of colored ants?
do you see any text from the kernel? If so can you give the last few
lines of text? Thanks. Also can you see where the kernel detects the
mmc? it should show the partitions <mmcblk0p1><mmcblk0p2> etc.. make
sure you have the correct root in your default.txt
set CMDLINE "root=/dev/mmcblk0p1"

hope this helps

Fabio Comolli wrote:
> Hi all.
> I can't make linux run on my rx3115. Steps I followed:
>
> * downloaded
> http://morgan.fbi.cz/pub/rx3715/gpe/30-nov-06/gpe-rx3715-0.8.4.tar.bz2
> * extracted wince-loader into internal memory
> * extracted sd-image into an empty mmc card formatted with FAT
> * run haret
>
> I can see the penguin image and the bar on the right. At the end of
> the download the screen messes up and stays so.
>
> It seems that the kernel crashes during load.
>
> Any ideas? I don't know if it can be important, but I have latest
> firmware installed (1.01.11).
>
> Best regards,
> Fabio
>
> (Please keep me in CC:)
> _______________________________________________
> Rx3700-port mailing list
> Rx3700-port_at_handhelds.org
> https://www.handhelds.org/mailman/listinfo/rx3700-port