Re: Rx3700-port Digest, Vol 24, Issue 2

> I've been trying to install Roman's GPE image following some tips in last
> Paul's
> mail. Following a Bulma tutorial I was able to make two partitions on my
> 1Gb SD
> card, the first FAT16 for using it with WinCE and the other one ext2 for
> GPE
> system.

That sounds fine, same setup as i used.

> I put HaRET 0.3.8 and other wince-loader files into first
> partition and
> GPE system up there in the ext2 partition, run it and go. And yes, GPE
> started
> ok (at leastthe first time), but I got a login window with two
> possibilities to
> log in: root an ... mmorgan... It seems to me that this is exactly Roman's
> prompt ... funny thing... I could do nothing so I restarted. I try one
> more
> time using HaRET 0.3.6 from IPaq file store, but... no log in window...
> sniff.
> Try again HaRET 0.3.8 and same results.

I found either loader worked (0.3.6 or 0.3.8), but like you the first time without knowing the
password (which is morgan) i just restarted it and after then couldn't get back to the login
prompt.
It did work again after deleting and re-copying the GPE files back across to the ext partition
for me. I think it must of been some corruption from not unmounting the partition when
restarting. So i would try that first.

Daniel

--------------------------------------------------------------
Sent with "Me-Mail", Boltblue's FREE mobile messaging service.
http://www.boltblue.com
Received on Wed Dec 06 2006 - 15:10:55 EST