Hi,
I'm trying to port linux on the same device, but until now I wasn't able to figure out if it booted correctly or not because I don't own a serial cable. Could you please send me your kernel configuration so that I can build it myself? If I'am able to boot I can help you with the fb driver. Until now I realized that the framebuffer is located at a strange offset (something like 0xa0000 aligned or so, I saved it somewhere on a backup disk that I haven't at handy right now).
Luca
>Hello,
>
>some time ago I found this side and asked for the progress of >intel-fb
>on the rover/mitac mio device.
>now I build a serial cable and can see the kernel booting. it >works fine
>but the initrd can not mount
>/dev/hda2 as it is written in /linuxrc.
>
>my device is a mitac mio168 with nec display (black, I know) >and
>sd/mmc-card only. hda2 exists and
>contains the root-fs in an ext2 formated partition.
>the module ide-disk and ide-cs is loaded bit /dev/hdaX is >unaccessable.
>is this only working with cf-cards?
>
>is the developement still running on this units? would be >nice if so :)
>
>regards
>Sascha
/earth is 98% full ... please delete anyone
you can.
------------------------------------------------------
Leggi GRATIS le tue mail con il telefonino i-mode™ di Wind
http://i-mode.wind.it/
Received on Wed Oct 03 2007 - 16:49:30 EDT
This archive was generated by hypermail 2.2.0 : Wed Oct 03 2007 - 16:49:46 EDT