On Sun, 16 Mar 2003 12:50:19 +0100 (CET), you wrote:
>On Fri, 14 Mar 2003, John Ankcorn wrote:
>
>> The problem is that the board only contains the following
>> parts:
>> (2) flash chips
>> (2) dram chips
>> (1) 140-pin connector
>>
>> The data and address busses are each run directly to the
>> connector (no multiplexing, etc), so there are 32 address pins
>> 32 data pins and 12 control lines. The design is extremely
>> simple; everything is just connected directly to the Strongarm
>> processor bus.
>
>is the board design fixed or could you make pins needed to program the
>flash chips avaliable via solder pads?
>
>this way we could program them without obtaining the connector, and save
>you alot of work and support problems
Are the flash chips removable? if they are then can't you just pull
them out and someone can reflash them in a programmer.
--Received on Mon Mar 17 13:56:44 2003
This archive was generated by hypermail 2.1.8 : Tue May 04 2004 - 09:46:01 EDT