On Fri, 14 Mar 2003, John Ankcorn wrote:
> The problem is that the board only contains the following
> parts:
> (2) flash chips
> (2) dram chips
> (1) 140-pin connector
>
> The data and address busses are each run directly to the
> connector (no multiplexing, etc), so there are 32 address pins
> 32 data pins and 12 control lines. The design is extremely
> simple; everything is just connected directly to the Strongarm
> processor bus.
is the board design fixed or could you make pins needed to program the
flash chips avaliable via solder pads?
this way we could program them without obtaining the connector, and save
you alot of work and support problems
jacek
Received on Sun Mar 16 2003 - 11:50:24 EST
This archive was generated by hypermail 2.2.0 : Mon Jul 25 2005 - 17:26:16 EDT