>
> So, the only options we have left is either program the flash on
> a "standard" flash programmer *before* soldering it to the board,
> OR to program the flash after soldering it to the board.
Well then it may be sufficient to make some place to solder few wires
on top side of PCB or make a few holes in the corner of the board to
connect just simple "jumper like" connector there. IMHO for flash
programming you need just a few wires.
> Regards,
> -Mark Gollahon
Adam Pribyl
Received on Fri Feb 02 2007 - 15:54:16 EST
This archive was generated by hypermail 2.2.0 : Fri Feb 02 2007 - 15:54:30 EST