Re: [jornada] prism wireless

I have prismII card, but should be mostly same. When you insert card to
module (orinoco_cs?) should be loaded automaticaly. New device eth0 should
be available in ifconfig and iwconfig. iwconfig says what is link quality,
but sometimes you also have to set up txpower (you card is receiving OK
but transmiting on 0 power. Try to use ifconfig to set up IP for the
iface instead ifup, maybe you'll get more info. ifup could even fail if
your card is requesting IP trough DHCP but your router does not provide
any.

Adam Pribyl

On Sat, 30 Jul 2005, Matthis Rouch wrote:

> Hello;
>
> I have bought a belkin pcmcia F506020 card of ebay and received it
> this morning. Woohoo -- or so I thought, but after having spent long
> hours it is still not working. So before I spend more time searching
> and editing configs, I would like to make sure there isnt anything
> jornada specific to perform.
> Since the card is base on Prism and is recognised by iwconfig I
> thought I didn't need to load any modules. Is this correct?
> But when I try to up the interface, I get "eth0 : New Link Status
> Association Failed (0006)"
>
>
> If this is an easy problem (rather than something where you have to
> check all my configs), please give me a hint! Thanks,
>
> Best regards;
>
> Matthis
> _______________________________________________
> jornada mailing list
> jornada_at_handhelds.org
> https://handhelds.org/mailman/listinfo/jornada
>

--