[iPAQ] Compaq WL110 wireless card

Hi all,

I'm also stuck trying to make my wireless card work.
I follow the instructions to install Familiar v0.4 on my iPAQ H3670
and everything went fine till the network setup.

> "Configure the iPAQ for the network (if you're using DHCP and PCMCIA/CF
> networking card, you might already have everything configured), and verify
> that everything is operational (e.g. ping familiar.handhelds.org). Be sure
> that you have created /etc/resolv.conf and added at least one nameserver
> entry. If you are using pump for DHCP, this will be taken care of for
> you."

At this point I don't know how to proceed. I intended to follow Andy's
suggestion

> # cat << _EOF_ > /etc/resolv.conf
> domain MYDOMAIN
> nameserver 192.168.1.1
> _EOF_
>
> # rmmod wvlan_cs
> # insmod wvlan_cs opts "network_name=MY_SECRET_SSID"
> # ifconfig eth0 192.168.1.2 netmask 255.255.255.0 up
> # route add default eth0
> # ntpdate mytimeserver.com
>
> insert your own ipaddress, SSID (if wireless) and timeserver, your domain
> and your nameserver.

but I think for my Compaq WL100 wireless card I need the wlan_ng
module. The newbie's question is, how can I download this module into
my iPAQ? What command is avaialble at the bootldr?

Thanks for your help,

        Juan
Received on Fri Sep 21 11:08:03 2001