[iPAQ] load bootldr problems

Hi,

I have an iPAQ H3670 (64MB US) and I am trying to install Linux.

So far I have been able to save the flash (verifying the md5sums with
the second set posted on [1]). After futzing around, I got minicom on
Linux to talk with the osloader on the iPAQ so I have "boot>". I type
"load bootldr" and then start sending bootldr-0000-2.14.8 via xmodem.
(minicom uses sx -vv to send.) A whole bunch of messages scroll by in
the dialog box too quickly to read. It stops with the following lines:

  Xmodem sectors/kbytes sent: 788/98kRetry 0: NAK on sector
  Retry 0: NAK on sector
  No ACK on EOT

  Transfer incomplete

  READY: press any key to continue...

Nothing every happens on the iPAQ. In particular, I do not see
"verifying ... done.". Thus I suspect that the bootloader is not
properly installed. However, "peek flash 0x0" prints EA00008E and
"peek flash 0x20" prints 646C7462 as it should. Naturally, I am
nervous about continuing on with the installation process.

Is bootldr installed or not? If it isn't, what should I do next?
(Repeating the process doesn't get me anywhere.) If it is, is it safe
to continue?

[1] http://www.handhelds.org/projects/wincerestoration.html

Mark

-- 
Mark K. Gardner
RADIANT Team, Advanced Computing (CCS-1)
Computer and Computational Sciences Division
Los Alamos National Laboratory
P.O. Box 1663, M.S. D451
Los Alamos, NM 87545
Email: mkg@lanl.gov
WWW:   http://public.lanl.gov/mkg/
Phone: 1-505-665-4953
--