Re: [iPAQ] usbnet ...

ok now the link seem to be up ...
at least seem my PC recognize iPAQ, in the log i found

Jun 13 08:49:19 motoko kernel: usb-uhci.c: $Revision: 1.259 $ time
20:12:08 Jun 12 2001
Jun 13 08:49:19 motoko kernel: hub.c: USB new device connect on bus1/1,
assigned device number 2
Jun 13 08:49:19 motoko kernel: usb.c: USB device 2 (vend/prod
0x49f/0x505a) is not claimed by any active driver.
Jun 13 08:49:39 motoko kernel: usb.c: registered new driver usbnet
Jun 13 08:49:39 motoko kernel: usb0: register usbnet 001/002, Linux
Device

and in fact i'm able to setup correctly the net interface on the PC with
ifconfig usb0 1.1.1.2 netmask 255.255.255.0 up

on the iPAQ i did about the same things ...
modprobe usb-eth
ifconfig usbf 1.1.1.1 netmask 255.255.255.0 up

and all seem fine ...

but i'm unable to comunicate
both on iPAQ and on PC if i ping the own side of usb net bus all seem
fine
but i'm unable to ping the other device ...
on PC log i notice

Jun 13 08:52:17 motoko kernel: NETDEV WATCHDOG: usb0: transmit timed out
Jun 13 08:52:57 motoko last message repeated 4 times

and repeated lot of time :(

i also notice that on iPAQ 'ifconfig usbf' stat that there is a lot of
RX errors
RX packets: 0 errors: 473344 dropped:0 overruna:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0

on PC sice ifconfig usb0 report
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:24 dropped:0 overruns:0 carrier:0

and i tried lot of time to ping on both side ... :(

-
 /-----------------------------------------------------------------------\
| Alessandro Gardich : gremlin@gremlin.it |
>-----------------------------------------------------------------------<
| Le aquile possono anche volare, |
| ma le talpe non vengono risucchiate nei jet. |
| |
| "Micol" |
 \-----------------------------------------------------------------------/
Received on Wed Jun 13 22:39:03 2001