[iPAQ] bootldr frozen, do I have a brick?

Hi there,
When using Bootblaster most versions I downloaded (and transfered via
ActiveSync) would only start for a brief second. I finally found
BootBlaster_1.8.exe to run fine. I have a HX4700 so I chose
bootldr-sa-2.20.4.bin to load as my bootldr. I selected it on the list
and it began programming the flash. An error message appeared stating
something like "cannot configure network". After waiting a few minutes
the device was still frozen with the error message still showing. I
turned it off and now it will not turn back on again.
 
If this is unfixable can I get some advice on getting HP to re-flash
this for me. Will leaving the device turned off for a while help?
 
Much help please.
Regards
Gavin.
 

______________________________________________________________________

This email has been scanned by the MessageLabs Email Security System
on behalf of the London Business School community.
For more information please visit http://www.messagelabs.com/email
______________________________________________________________________
Received on Thu Aug 09 2007 - 11:57:20 EDT