[iPAQ] reloading wince

Hello,
 
I'm working with a 5550 iPAQ, and Bootloader3600 that I downloaded in the tarball for Familiar.
 
I'm trying to put wince back onto the iPAQ. Unfortunately my saved wince_image.gz file is corrupted, or at least there's something wrong with the file when I try to verify it using WinGZip.
 
I followed the instructions to restore wince using an update from HP on this page:
 
http://www.handhelds.org/hypermail/h5400-port/5/0562.html
 
This is a transcript of what I got after I transferred the file, after it verified the file and did all the "Erasing sector" stuff:

        verifying ...
        calculated crc32 = 0xC6A9957E
        desired crc32 = 0xC6A9957E
        formatting ... done.
        boot>
         
        A friend told me to ls before trying to boot wince:
         
        boot> ls
        Scanning all of flash for your JFFS2 convenience. Est Time: 6-12 seconds!
        build_list: max = 01FBFFBC
        ...........................Offset = 00166078
        ...........................
        .................................
        dir entries = 00000000
        frag entries = 00000000
        +4 increments = 000D3BCB
        +file_offset increments = 00000002
         
        This is what I got when I tried boot wince:
         
        boot> boot wince
        Disabling LCD controller
         
        The screen on the iPAQ went black, and then I don't get anything. I've tried pushing the reset button, and I've tried a hard reset, and nothing happened. I can still access the bootloader by pressing the joypad and the reset switch.
         
        Any ideas on what I should do next?
         
        Many thanks,
         
        Diane
         
         

Received on Thu Jul 29 14:54:57 2004