RE: [iPAQ] HELP - Cannot restore WinCE

Ok, No flow worked. Could have sworn I tried that last night.

Anyway, do I have to xmit the file through the boot prompt via xmodem, or can the file be copied someplace in the filesystem to boot from?

If I can place the wince.gz file in a location in the filesystem so bootldr will reload it, where do I place it?

Thanks.

-----Original Message-----
From: ipaq-bounces_at_handhelds.org [mailto:ipaq-bounces_at_handhelds.org] On Behalf Of Toby Gray
Sent: Thursday, April 22, 2004 8:24 AM
To: ipaq_at_handhelds.org
Subject: Re: [iPAQ] HELP - Cannot restore WinCE

On Thursday 22 April 2004 22:54, Tim Underwood quoth thusly:
> When I press the center joypad button, and use the stylus to reset, I
> get the bootldr screen, and there is a hardware button set to "Serial
> Bootloader Console". When I press that - I DO get the "boot" prompt,
> but keystrokes from the terminal emulator are not received.

The fact the keystrokes are not getting through presumably explains why there was no response when you were hitting spacebar before.

Have you turned off both software AND hardware flow control in your terminal program?

-----------------------------
/"\
\ /    ASCII Ribbon Campaign
 X      against HTML e-mail
/ \
_______________________________________________
Open Source Software for Compaq iPAQ Handhelds.
iPAQ mailing list
iPAQ_at_handhelds.org
https://handhelds.org/mailman/listinfo/ipaq
irc://irc.openprojects.net #ipaq
Received on Thu Apr 22 2004 - 15:47:23 EDT