RE: [iPAQ] Re: 3630+BT sleeve BlueZ BCSP working^2 ... :)

"pskey" changes the Bluetooth chip's firmware. The chip must then be
reset to make the changes take effect.

        - Andrew

> -----Original Message-----
> From: Des Johnston [mailto:D.A.Johnston_at_ma.hw.ac.uk]
> Sent: Wednesday, October 30, 2002 5:09 PM
> To: Des Johnston
> Cc: ipaq_at_handhelds.org
> Subject: [iPAQ] Re: 3630+BT sleeve BlueZ BCSP working^2 ... :)
>
>
> Very odd, after leaving things overnight and going back to
> the iPAQ that wasn't playing initially with the CF+BT sleeve
>
> setserial /dev/tts/0 baud_base 1000000
> hciattach /dev/tts/0 bcsp 230400
>
> now works fine........
>
> bnep, pand etc all work too to give a network connection.
>
> Does the chip need a little while to settle down after pskey
> is used on it?
>
>
> Des Johnston
>
> ================================================================
>
>
> On Wed, 30 Oct 2002, Des Johnston wrote:
>
> >
> > Using the bluez packages from unstable on top of 0.6
> > I have one 3630 iPAQ that will work with the (same) CF+BT sleeve in
> > bcsp mode and another which flatly refuses. In both cases
> the commands
> > used are:
> >
> > setserial /dev/tts/0 baud_base 1000000
> > hciattach /dev/tts/0 bcsp 230400
> >
> > On the working iPAQ hciattach gives a timeout without the setserial
> > first.
> >
> > I get various hci_ errors on the non-compliant iPAQ (I'll post them
> > once I get it by me again). It's probably not relevant but
> the working
> > iPAQ was a 0.5.3 upgrade and the sulking one a fresh 0.6 install.
> >
> >
> > Des Johnston
> >
> >
> >
> >
> >
> >
> >
> > >Use the bluez packages from the unstable feed.
> >
> > >hciattach is not broken - the version of hcitattach in 0.6 doesn't
> > >support BCSP.
> >
> > >Upgrade.
> _______________________________________________
> Open Source Software for Compaq iPAQ Handhelds.
> iPAQ mailing list
> iPAQ_at_handhelds.org
> http://handhelds.org/mailman/listinfo/ipaq
> irc://irc.openprojects.net #ipaq
Received on Thu Oct 31 2002 - 12:11:06 EST