Just found out that I needed to instal lrzsz too (debian install of minicom
does not install it and apparently -- bootldr faq -- minicom needs it)
Get NAK on Sector messages (but could be no problem)
W
>
> Just installed bootldr 2.18.48 on a blank (read wince only) device.
> Installation is OK (i.e reset works for WINCE as well as for bootlrd
> splash screen terminal works too ... see further)
>
> Just wanted to load root partition (with bootflash familiar 0.5.3...)
> bootldr says ..
>
> serial console at your service...
> boot> pflash 0x40000 0xffff 0
> addr=00040000
> len=0000FFFF
> protect=00000000
> Protect=00000000
> boot> partition reset
> defining partition: bootldr
> defining partition: root
> defining partition: asset
> boot> set ymodem 1
> setting param <ymodem> to value <1>
> boot> load root
> partition root is a jffs2 partition:
> expecting .jffs2 or wince_image.gz.
> After receiving file, will automatically uncompress .gz images
> loading flash region root
> using ymodem
> ready for YMODEM transfer...
> CC.....Too many errors during receive; giving up.
> download error. aborting.
>
> What is wrong (ftp-ing megabytes worked just fine ...)
>
> W
> _______________________________________________
> Open Source Software for Compaq iPAQ Handhelds.
> iPAQ mailing list
> iPAQ@handhelds.org
> http://handhelds.org/mailman/listinfo/ipaq
> irc://irc.openprojects.net #ipaq
Received on Sat Oct 12 17:30:48 2002
This archive was generated by hypermail 2.1.8 : Tue May 04 2004 - 09:44:57 EDT