Check the following:
1. Make sure you have hardware handshaking turned off in Hyperterminal.
2. Verify that the baud rate is set to 115.2 kBaud, 8N1
3. If you are running WinCE on your iPAQ, you must hold down the center
of the joypad while pushing the reset button - otherwise your iPAQ
autodetects the WinCE image and boots it immediately.
- Andrew
> -----Original Message-----
> From: Robles Lopez [mailto:nrobles@ees2.oulu.fi]
> Sent: Monday, February 18, 2002 5:28 AM
> To: ipaq@handhelds.org
> Subject: [iPAQ] boot prompt?
>
>
> I have a valid bootloader(version 2.18.01) in my iPAQ.I have
> rebooted it
> but I can't see the boot> prompt.My iPAQ is attached to a
> host computer via
> serial cradle with Hyperterminal.
> What can I do?
> Natalia
>
> _______________________________________________
> Open Source Software for Compaq iPAQ Handhelds.
> iPAQ mailing list
> iPAQ@handhelds.org
> http://handhelds.org/mailman/listinfo/ipaq
> irc://irc.openprojects.net #ipaq
>
Received on Mon Feb 18 06:44:10 2002
This archive was generated by hypermail 2.1.8 : Tue May 04 2004 - 09:44:32 EDT