Re: [iPAQ] serial Gamepad sleeve driver

The standard Stinger driver that comes with the kernel should work (at least
it does on my laptop). The problem with the Ipaq was that the Stinger
hardware required some signals that the Ipaq serial driver / hardware were
not able to generate.

So I am assuming that this device doesn't have that problem. Then, the only
question is if this device uses the same protocol as the Stinger. If so,
then the Stinger driver should work fine. Otherwise, you might have to
experiment to determine the protocol and roll your own driver (which
shouldn't be too hard). I am thinking of buying one of these too, so if I
do, I'll start hacking at it too.

Good luck!
Jordan

On Tuesday 29 January 2002 11:12, Jonathan Jackson mentioned:
> All,
> Can anyone point me in the right direction for the serial Gamepad
> driver(s) that have been written for Familiar?
> I picked up one of the Hanaho joypad sleeves. I found some dead links to
> the Stinger driver, and I think this is what I am looking for. Has
> anyone else had any luck with this device?
>
> --Jon
Received on Tue Jan 29 10:49:57 2002