Re: [iPAQ] Brick, definite brick

Where's the power switch?

On Sat, 12 Jan 2002, Ross J. Reedstrom wrote:

> Have you tried a hard reset? I.e., flip the power switch, wait a few
> seconds, and slide it back.
>
> Ross
>
>
> On Fri, Jan 11, 2002 at 06:56:43PM -0500, Vincas Ciziunas wrote:
> > Hi,
> > I was in bootldr_v2_16_19, and right after doing a :
> > partitions reset
> >
> > I did a :
> > KernelCmp kernel
> >
> > The iPAQ did not like this, and when I looked at the screen, the pretty
> > bootldr screen was replaced by a bar of colors going up and down along the
> > long end of the LCD, a little bit right off-center. It no longer loads up
> > the bootldr, and I see a very minor change in the color of the screen when
> > I hit the reset button. What is the procedure for a bricked ipaq?
> > Thanks.
>

-------------------------------------------------------------------------------

                                --Vincas Ciziunas--
      (College Student, Linux Geek, Music Nut, Virginian, Computer Science Major)
                 fizban@tamos.net vciziuna@gmu.edu winkie@faceprint.com
                           http://www.tamos.net/~fizban
        "There's nothing worse in the world than an angry tree," --Bob Ross

-------------------------------------------------------------------------------
Received on Sat Jan 12 08:23:36 2002