RE: [iPAQ] SA1110 Kernel for iPaq

Hello Vasant;

The memory map is fairly standard. I believe that the kernel expects to be
at c0008000. You may have to pass a parameter to the kernel at the command
line if you have less than 32M of ram. (mem=16M for example).

You can find a zImage at ftp://ftp.handhelds.org/pub/linux/compaq/ipaq/v0.12

You can find an updated tool chain with instructions at
ftp://ftp.handhelds.org/pub/linux/arm/toolchain

I hope this works for you,

Best Regards,

--George

George France, france@crl.dec.com
Cambridge Research Laboratory, Compaq Computer Corporation
One Cambridgecenter MS: CRL
Cambridge, MA 02142 USA

> -----Original Message-----
> From: Vasant Ramasubramanian [mailto:vasantr@utdallas.edu]
> Sent: Friday, August 11, 2000 11:29 AM
> To: ipaq@handhelds.org
> Subject: [iPAQ] SA1110 Kernel for iPaq
>
>
> Does the kernel that the iPaq boot use a highly specific
> memory map? If
> not could someone send me a relatively new iPaq kernel or
> tell me where to
> find one? I need a relatively generic SA1110 kernel with
> serial on console
> 3 (@9600) and something that expects to be placed @ 0xc0000000 in RAM.
>
> Thanks,
> Vasant.
>
> P.S.
> My toolchain is out of sync and I am at a loss for high speed Internet
> access.
>
> _______________________________________________
> iPAQ mailing list
> iPAQ@handhelds.org
> http://handhelds.org/mailman/listinfo/ipaq
>
Received on Fri Aug 11 13:41:32 2000