suspend-resume and bluetooth problems

Hi everyone

Just before I explain my problems, let me say that this porting effort
is very good and illustrative. It's too bad that the original site is
down, I had to get the GPE image from blendo.de

First, I was trying out the GPE image on my h6315 following the
instructions that I found inside the bz2 archive at blendo's, and it
specifically states that resume/suspend using the power button works
fine. I, however, haven't been able to do that yet: it only works if I
manually do the "echo mem > /sys/power/state" thing.

Regarding bluetooth, I tried the steps outlined in
http://www.handhelds.org/moin/moin.cgi/hpipaqh6300bluetooth but wasn't
successful. After the hciattach command I get this:

# hciattach ttyS0 texas
Failed to read init response (READ_LOCAL_VERSION_INFORMATION): Sucess
Can't initialize device: Illegal seek

Is there anything that I'm missing? Everything else works, though. I
have successfully sent SMSs and have placed a couple of calls. I am
using a 256MB SD card (Kodak branded and I got it for free, so I don't
know who the manufacturer is). I'll try enabling the bluetooth module
at WinCE, but I'm more worried about the suspend/resume thing.

One last thing: is it normal for the battery to heat up a little? The
heating is barely noticeable but I still feel it.

Thanks for your attention, I hope someone's got answers

Regards

Juan Pablo Ramirez
GPG Key 0xE5296C68 at the usual servers
Received on Thu May 17 2007 - 23:55:25 EDT