Hello, Gert.
The thing is, with my problem I get an input/output error rather than the ability to read/write to the MMC.
I get the below error when accessing it:
[mmc_samsung.c:1107] mmc_s3c_split_status DUMMY MMC_ERROR_CRC
[mmc_samsung.c:1120] mmc_s3c_split_status get_response
[mmc_protocol.c:150] mmc_cim_read_write_block invalid card state 6
[mmc_protocol.c:205] mmc_cim_read_write_block failure during cmd 13, error 0 (NO_ERROR)
end_request: I/O error, dev fe:02 (mmc), sector ....
Where .... is replaced by a specific sector..
I have reflashed the iPAQ and got it working to no avail with either "fresh" images or previously used images.
I hope someone has a solution.
Thanks,
Ahmad
--- "Gert Menke" <g.menke@gmx.net> wrote:
Hi Ahmad,
> [...]
> [mmc_samsung.c:1143] mmc_s3c_split_status : ERROR READ COMMAND
> 0x00000011,0x00000001,0x00001004
> [...]
> Has anyone ever experienced this? Anyone know how to fix this? I seriously
> hope that my SD drive isn't messed up, as I'd hate to pay over $100US just
> to fix it.
I get the same messages here, so it's probably not your card's fault.
My card seems to work fine despite these errors, but it is very slow.
No idea how to fix this, though.
Regards,
Gert
_______________________________________________
H5400-port mailing list
H5400-port@handhelds.org
https://www.handhelds.org/mailman/listinfo/h5400-port
_____________________________________________________________
yourname@digiverse.net
http://www.digiverse.net
Received on Fri Jul 9 09:51:16 2004
This archive was generated by hypermail 2.1.8 : Fri Jul 09 2004 - 09:51:45 EDT