On Fri, 2004-06-25 at 14:59, Matus Harvan wrote:
> I think you meant h5400_lcd.c, thather than lcd_h5400.c. I compiled both
> mq1100fb.c and h5400_lcd.c as modules, but when modprobed, nothing
> happened. Ok, the screen blinked, but I could not start gpe. How do I
> find out if it works? So far I have been looking for /dev/fb/0, which
> does not show up. I also installed devfsd, but /dev/fb/0 still does not
> show up.
You shouldn't need to install devfsd. Loading h5400_lcd and mq1100fb
should be sufficient to make /dev/fb/0 appear. If this isn't working,
it sounds like the code needs to be debugged some more.
> I also have modprobed pxafb and mq11xx_base. What other modules do I need?
Don't load pxafb; that will only confuse matters.
> You said things worked/should work. Have you tried it on an iPAQ? If
> yes, could you share your .config?
Yes, but not very recently. My .config is the same as the one in CVS.
The SHAMCOP modules will probably not work on h5400 at the moment, but
it might be useful to compare them against the SAMCOP equivalents to see
if anything needs to be changed.
p.
Received on Fri Jun 25 10:04:52 2004
This archive was generated by hypermail 2.1.8 : Fri Jun 25 2004 - 10:05:31 EDT