Re: h5555: MMC and PCMCIA status?

Thanks for responding, Phil. Also thanks for all the hard work on this project.

The sleeve does get recognized, but I don't get any response at all from any cards inserted into either of the slots.

The hotplug scripts gets run for adding the sleeve device, but I've noticed that the cardctl and PCMCIA procfile information doesn't change whether the sleeve is present or not. Battery information is shown when the sleeve is present, so I don't think there's a problem with communicating with the sleeve itself.

After inserting a card, any "cardctl {info|status|config|ident}" show the same as if there were no card present. Nothing is sent to syslog. I've also tried to force with "cardctl eject" and "cardctl insert" with no change.

I could pick up and try one of the standard single-slot sleeves if there might be a difference between the two. Any suggestions?

-- 
mike
On Wednesday, November 5, 2003 at 05:33:22 -0500, Phil Blundell wrote:
>Jamey has done some work on the MMC slot driver, and I've poked at it a
>little bit as well, but it's not usable yet.
>
>Can you be more specific about what happens with your PCMCIA problem?  
>Is the sleeve correctly detected? Do the cards show up in "cardctl
>ident"?
>
>p.