Re: how to see haret working

On Fri, 27 Feb 2004 00:12:45 +0100
Davide Corio <dcorio_at_sviluppolibero.it> wrote:

> I think I must connect via serial cable or irda with my ipaq, but I
> can't set correctly minicom to works properly.
> With irda, if I have attached ir to ttyS1.
Ok, here it goes again:
- Stop the irda stack (service irda stop)
- Make sure there are no *ir* modules loaded (lsmod | grep ir)
- Set up minicom to use ttyS1
- Add a "console=ttyS2,115200n8" switch to kernel command line
(in default.txt).
- Use a hand camera to make sure something is actually sent from your PC
and/or PDA (you can see the IR diode blinking through camera visor).

If all this doesn't work, there could be something wrong with the IrDA
code I wrote in h2200.c.

You can also check if your PC's IrDA works by trying to beam something
from WinCE to your PC while running minicom: you should see garbage in
minicom (works best with wraparound turned on, Alt+W).

--
Greetings,
   Andrew