>>note, maybe this comment should be put on the wiki page? seems to be a
frequent question
>>
Calibration doesnt quite work yet, itz being worked on thatz why it doesnt work,
everything iz in the right place where u put it
<<
Quoting Daniel E Middleton <dmiddle2@csc.com>:
> Hi there,
>
> Apologies in advance as I am by no means an expert.
>
> Basically, I have been following the instructions for booting to linux (GPE
> or Opie) that I found on this page
> (http://handhelds.org/moin/moin.cgi/HpIpaqH2200CFBoot)
> using the files that I downloaded from here
> (http://regul.uni-mb.si/~pvic/ipaq/h2200_cf_boot/)
>
> I can boot to the screen which allows you to choose between opie and gpe
> ok, then if I click on opie it goes to the calibration screen and goes
> round and round forever (however many times I click on it). and if I select
> gpe then it goes into a GUI that I can't seem to calibrate at all.
>
> I think the problem may be that I haven't put the compiled modules files in
> the correct place, but I am not sure where to put them.
>
> Currently I have my CF Card structured as follows.
>
> \\CF\linux\haret.exe
> \\CF\linux\startup.txt
> \\CF\linux\initrd
> \\CF\linux\zimage
> \\CF\linux\rootfs
> \\CF\linux\setup.txt
> \\CF\compiled_modules.tgz
>
> Any assistance on this would be greatly appreciated.
>
> Dan
>
>
>
>
----------------------------------------------------------------------------------------
>
> This is a PRIVATE message. If you are not the intended recipient, please
> delete without copying and kindly advise us by e-mail of the mistake in
> delivery. NOTE: Regardless of content, this e-mail shall not operate to
> bind CSC to any order or other contract unless pursuant to explicit written
> agreement or government initiative expressly permitting the use of e-mail
> for such purpose.
>
----------------------------------------------------------------------------------------
>
>
>
> _______________________________________________
> H2200-port mailing list
> H2200-port@handhelds.org
> https://handhelds.org/mailman/listinfo/h2200-port
>
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
Received on Thu Sep 16 19:57:35 2004
This archive was generated by hypermail 2.1.8 : Thu Sep 16 2004 - 19:57:56 EDT