Hi Peter,
> As I (and Dominic) already mentioned, there seem to be some problem with
>
>screen calibration. I could start only opie (sometimes), but gpe didn't
>work. In opie screen calibration when everything works ok, I touch screen
>only 8 times (I think), but sometimes calibration failed and at the end bash
>prompt shows up. But cross for screen callibration is still on the screen. I
>think this is not problem because of CF boot. Can someone explain, how
>screen calibration works? There was discussion on this list some time ago,
>but I didn't found some useful information. Is data from calibration saved
>anywhere and used in next boot or not?
>
As far as I remember, calibration data are stored in /etc/xtscal.conf.
However, we need the Xserver from OpenEmbedded to take these data into
account. Previously, screen coordinate conversion using calibration data
was done through an extra driver (h3600_ts), but we'd rather use the OE
solution instead.
That's why we need an OpenEmbedded rootfs!
:-)
Michael.
-- Michael Opdenacker http://free-electrons.comReceived on Tue Aug 10 10:31:39 2004
This archive was generated by hypermail 2.1.8 : Tue Aug 10 2004 - 10:32:11 EDT