Re: H1930 with linux

When you booted the console-only initrd, there are two ways to login:
over a serial infrared connection, and using ssh over the USB network.
The latter one is for most people the best way, but it might be a bit
difficult to set it up. You can use
http://handhelds.org/moin/moin.cgi/UsbNet
as a guide for that.
To run a graphical system (Opie is broken, use GPE), you must have either
an SD or MMC card, or run it on NFS over USB. The latter is just bad, as it
also needs your ipaq to be plugged in constantly. So you should go buy
an SD card.
Installing in the ROM memory is not possible. We can write the ROM of
the ipaq,
preferably with one of the jffs filesystems, but we have no way to boot
it since
there is no bootloader support (yet).

Good luck, and have fun!

Arjan

Iñaki Cormenzana wrote:
> Thanks, I could make work linux with haret-0.3.6
> <http://anymore.nl/ipaq/haret-0.3.6.exe> .
>
> perhaps it is an idiot question, but how I key in for login if I do
> not have a keyboard for ipaq?.
>
> When i reset the iPAQ (after running linux), is reinitiated
> completely, flock the system by default, that is a problem.
>
> Finally, if it wanted to run a Graphical system like Opie and I do not
> have a memory sd, it is impossible to create the partition ext2 in the
> native memory?
>
> Thanks for everything and successes!
>
> --
> Iñaki Cormenzana Méndez
>
> Security Research & Computer science Deliriums.
> http://www.proxxo.com.ar
> SoulBlack`s Staff
> http://www.soulblack.com.ar