I just hit the same problem tonight. In my case the ipaq battery went dead a
few minutes later, so I assumed it was just a power problem. Everything
started working again after plugging the power cable in.
Danny
> I found that the CF shows erroneous behavior after Suspend/Resume cycle.
> The problem only occurs when the CF memory card is mounted.
>
> The error as captured at minicom looks like:
> ...
> hda: status error: status=0x00 { }
> hda: driver not ready for command
> ide0:reset: master: error (0x00?)
> ...
>
> Sometime the error messages keep flooding the screen. In short /mnt/hda
> is not accessible anymore after Suspend/Resume cycle. To reproduce the
> error, you probably need to wait for about a minute before resuming.
> Otherwise it appears normal.
>
> I have a CF Lan card but it works alright across the Suspend/Resume
> cycles.
>
> Could you tell me if you have similar experience? I am not sure if it's
> my hardware problem or not.
>
> Thanks a lot for checking out.
>
> Regards
> Lawrence
Received on Sun Jul 22 20:49:52 2001
This archive was generated by hypermail 2.1.8 : Tue May 04 2004 - 09:38:28 EDT