Re: seg fault on iwconfig?

I'm getting a a seg fault at a certain point during xdopewars aswell.
----- Original Message -----
From: "Ellen Dash" <edash_dgi@hotmail.com>
To: <familiar@handhelds.org>; <ipaq@handhelds.org>
Sent: Sunday, June 03, 2001 8:13 PM
Subject: [Familiar] seg fault on iwconfig?

> I'm still trying to get a wireless card to work with my Linksys AP/Router
> configuration ... so I upgraded to Familiar .4 (complete) with some sort
of
> hope that it might help. Still no joy. ... (but the installation was very
> smooth!)
>
> Now, when I do iwconfig, I get a segmentation fault. Anyone know what
might
> be causing this? Below is what I get when the card starts up, and then
> ifconfig and iwconfig.
>
> Thanks for any help that you can provide.
>
> Ellen
>
>
> Starting PCMCIA services: modulesLinux PCMCIA Card Services 3.1.22
> options: [pm]
> SA-1100 PCMCIA (CS release 3.1.22)
> bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=0
> bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=1
> bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=0
> cardmgr.
> # cardmgr[710]: starting, version is 3.1.20
> cardmgr[710]: watching 2 sockets
> cardmgr[710]: Card Services release does not match
> cardmgr[710]: initializing socket 0
> cardmgr[710]: socket 0: Lucent Technologies WaveLAN/IEEE Adapter
> cardmgr[710]: executing: 'modprobe wvlan_cs port_type=1
> network_name=linksys channel=6 station_name=dash2'
> wvlan_cs: WaveLAN/IEEE PCMCIA driver v1.0.6
> wvlan_cs: (c) Andreas Neuhaus <andy@fasta.fh-dortmund.de>
> wvlan_cs: ``station_name'' is an obsolete module parameter, please use
> iwconfig.bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=0 reset=0
> bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=0 reset=0
> wvlan_cs: index 0x01: Vcc 5.0, irq 42, io 0xf6000000-0xf600003f
> wvlan_cs: Registered netdevice eth0
> wvlan_cs: MAC address on eth0 is 00 02 2d 2b 91 f4
> cardmgr[710]: executing: './network start eth0'
> modprobe: modprobe: Can't locate module net-pf-4
> modprobe: modprobe: Can't locate module net-pf-5
> modprobe: modprobe: Can't locate module net-pf-4
> modprobe: modprobe: Can't locate module net-pf-5
> modprobe: modprobe: Can't locate module net-pf-4
> modprobe: modprobe: Can't locate module net-pf-5
> modprobe: modprobe: Can't locate module net-pf-4
> modprobe: modprobe: Can'twvlan_cs: MAC address on eth0 is 00 02 2d 2b 91
> f4
> locate module net-pf-5
> cardmgr[710]: + ./network: /sbin/ifuser: not found
>
>
> .....# ifconfig
> eth0 Link encap:Ethernet HWaddr 00:02:2D:2B:91:F4
> inet addr:192.168.1.50 Bcast:192.168.1.255
> Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:100
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
> Interrupt:42
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> UP LOOPBACK RUNNING MTU:3904 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
>
> # iwconfig
> modprobe: modprobe: Can't locate module net-pf-4
> modprobe: modprobe: Can't locate module net-pf-5
> lo no wireless extensions.
>
> eth0 IEEE 802.11-DS ESSID:"linksys" Nickname:"familiar"
> Frequency:2.437GHz Sensitivity:1/3 Mode:Managed
> Access Point: 00:04:5A:26:5B:5F
> Bit Rate=11Mb/s RTS thr:off Fragment thr:off
> Encryption key:off
> Power Management:off
> Link quality:60/92 Signal level:-34 dBm Noise level:-94 dBm
> Rx invalid nwid:0 invalid crypt:0 invalid misc:0
>
> Segmentation fault
>
>
>
> _________________________________________________________________
> Get your FREE download of MSN Explorer at http://explorer.msn.com
>
> _______________________________________________
> Familiar mailing list
> Familiar@handhelds.org
> http://handhelds.org/mailman/listinfo/familiar
>
Received on Sun Jun 3 12:44:54 2001