seg fault on iwconfig?

I'm still trying to get a wireless card to work with my Linksys AP/Router
configuration ... so I upgraded to Familiar .4 (complete) with some sort of
hope that it might help. Still no joy. ... (but the installation was very
smooth!)

Now, when I do iwconfig, I get a segmentation fault. Anyone know what might
be causing this? Below is what I get when the card starts up, and then
ifconfig and iwconfig.

Thanks for any help that you can provide.

Ellen

Starting PCMCIA services: modulesLinux PCMCIA Card Services 3.1.22
  options: [pm]
SA-1100 PCMCIA (CS release 3.1.22)
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=0
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=1
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=0
cardmgr.
# cardmgr[710]: starting, version is 3.1.20
cardmgr[710]: watching 2 sockets
cardmgr[710]: Card Services release does not match
cardmgr[710]: initializing socket 0
cardmgr[710]: socket 0: Lucent Technologies WaveLAN/IEEE Adapter
cardmgr[710]: executing: 'modprobe wvlan_cs port_type=1
network_name=linksys channel=6 station_name=dash2'
wvlan_cs: WaveLAN/IEEE PCMCIA driver v1.0.6
wvlan_cs: (c) Andreas Neuhaus <andy_at_fasta.fh-dortmund.de>
wvlan_cs: ``station_name'' is an obsolete module parameter, please use
iwconfig.bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=0 reset=0
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=0 reset=0
wvlan_cs: index 0x01: Vcc 5.0, irq 42, io 0xf6000000-0xf600003f
wvlan_cs: Registered netdevice eth0
wvlan_cs: MAC address on eth0 is 00 02 2d 2b 91 f4
cardmgr[710]: executing: './network start eth0'
modprobe: modprobe: Can't locate module net-pf-4
modprobe: modprobe: Can't locate module net-pf-5
modprobe: modprobe: Can't locate module net-pf-4
modprobe: modprobe: Can't locate module net-pf-5
modprobe: modprobe: Can't locate module net-pf-4
modprobe: modprobe: Can't locate module net-pf-5
modprobe: modprobe: Can't locate module net-pf-4
modprobe: modprobe: Can'twvlan_cs: MAC address on eth0 is 00 02 2d 2b 91
f4
locate module net-pf-5
cardmgr[710]: + ./network: /sbin/ifuser: not found

.....# ifconfig
eth0 Link encap:Ethernet HWaddr 00:02:2D:2B:91:F4
          inet addr:192.168.1.50 Bcast:192.168.1.255
Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
          Interrupt:42

lo Link encap:Local Loopback
          inet addr:127.0.0.1 Mask:255.0.0.0
          UP LOOPBACK RUNNING MTU:3904 Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

# iwconfig
modprobe: modprobe: Can't locate module net-pf-4
modprobe: modprobe: Can't locate module net-pf-5
lo no wireless extensions.

eth0 IEEE 802.11-DS ESSID:"linksys" Nickname:"familiar"
          Frequency:2.437GHz Sensitivity:1/3 Mode:Managed
          Access Point: 00:04:5A:26:5B:5F
          Bit Rate=11Mb/s RTS thr:off Fragment thr:off
          Encryption key:off
          Power Management:off
          Link quality:60/92 Signal level:-34 dBm Noise level:-94 dBm
          Rx invalid nwid:0 invalid crypt:0 invalid misc:0

Segmentation fault

_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
Received on Sun Jun 03 2001 - 12:12:13 EDT