/sbin/ifuser missing!!!

Hi,
I just installed familiar with kernel 2.4.7-rmk3-np1-devfs.
My dual pc-card jacket now is working fine. I also installed
the kernel modules for my 3com 3c574 ethernet card.

My problem is that /sbin/ifuser is missing, so the network
cannot be configured. I use static ip (don't have a DHCP configured).
Where can I get ifuser???? Is it needed if DHCP is used instead of
a static IP?

The kernel and root images I used are:
zImage-2.4.7-rmk3-np1-devfs-hh2
task-bootstrap-2.4.7-rmk3-np1-devfs-hh2.jffs2

I grabbed them from:
ftp://lorien.handhelds.org/pub/linux/feeds/lwedemo/

The error message is:
sh-2.03# bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=0
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=1
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=50 reset=0
cardmgr[83]: initializing socket 0
cardmgr[83]: socket 0: 3Com 572/574 Fast Ethernet
cardmgr[83]: executing: 'modprobe 3c574_cs'
3c574_cs.c v1.08 9/24/98 Donald Becker/David Hinds, becker_at_scyld.com.
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=0 reset=0
bitsy_pcmcia_configure_socket: socket=0 vcc=50 vpp=0 reset=0
eth0: 3C574-TX Fast EtherLink PC Card at io 0xf6000300, irq 42, hw_addr
02:02:02
:02:02:02.
  ASIC rev 2, 8K FIFO split 5:3 Rx:Tx, MII interface.
eth0: command 0x5800 did not complete!
cardmgr[83]: executing: './network start eth0'
eth0: command 0x5800 did not complete!
cardmgr[83]: + ./network: /sbin/ifuser: No such file or directory

Thanks!
Manolis
Received on Sun Sep 02 2001 - 14:18:04 EDT