Here's what's happening...
"Kernel panic: No init found. Try passing init= option
to kernel."
Here is the complete boot process...
begin:
boot> boot
booting flash...
kernel_magic=E1A00000
kernel_region_words[9]=016F2818
Linux ELF flash_imgstart=50080000 size=000C0000
dest=C0000000 offset=00008000
MMU Control=C19F4071
copying Linux kernel ... done
linuxEntryPoint: C0008000
kernel_image_dest: C0000000
kernel_image_offset: 00008000
C0008000: E1A00000
C0008004: E1A00000
C0008008: E1A00000
C000800C: E1A00000
C0008010: E1A00000
C0008014: E1A00000
C0008018: E1A00000
C000801C: E1A00000
C0008020: EA000002
C0008024: 016F2818
root_filesystem_name=ramdisk
argc=00000002
args=noinitrd root=/dev/mtdblock/3 init=/linuxrc
console=ttySA0
setting boot parameters
get_param: could not find parameter system_rev
Setting up Linux parameters at address=C0000100
using_ramdisk=00000001
initrd_start=346C7466
dram_size=02000000
nr_pages=00002000
command line is: noinitrd root=/dev/mtdblock/3
init=/linuxrc console=ttySA0
linuxEntryPoint=C0008000
Booting Linux image
Uncompressing
Linux....................................... done,
booting the ker
nel.
Linux version 2.4.3-rmk2-np1 (root_at_step) (gcc version
2.95.4 20010319 (Debian pr
erelease)) #2 Mon May 14 12:21:48 PDT 2001
Processor: Intel StrongARM-1110 revision 6
Architecture: Compaq iPAQ
On node 0 totalpages: 8192
zone(0): 8192 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: noinitrd root=/dev/mtdblock/3
init=/linuxrc console=ttySA0
Console: colour dummy device 80x30
Calibrating delay loop... 194.15 BogoMIPS
Memory: 32MB = 32MB total
Memory: 30872KB available (987K code, 256K data, 60K
init)
Dentry-cache hash table entries: 4096 (order: 3, 32768
bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096
bytes)
Page-cache hash table entries: 8192 (order: 3, 32768
bytes)
Inode-cache hash table entries: 2048 (order: 2, 16384
bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society
NET3.039
Starting kswapd v1.8
Console: switching to colour frame buffer device 40x30
pty: 256 Unix98 ptys configured
block: queued sectors max/low 20224kB/6741kB, 64 slots
per queue
JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by
Axis Communications AB.
SA1100 serial driver version 1.3
ttySA0 on SA1100 UART3 (irq 17)
ttySA1 on SA1100 UART1 (irq 15)
ttySA2 on SA1100 UART2 (irq 16), using IRDA
SA1100 flash: probing for 4 partitions (buswidth = 4)
SA1100: Found 2 x16 devices at 0x0 in 32-bit mode
JEDEC ID: 89 17
0: offset=0x0,size=0x40000,blocks=64
No RedBoot partition table found. Using default
partitioning
parse_bootldr_partitions:
partition_table_offset=0x40000
parse_bootldr_partitions: magic=0x646c7470
parse_bootldr_partitions: npartitions=0x4
partition bootldr o=0 s=40000
partition params o=40000 s=40000
partition kernel o=80000 s=80000
partition root o=100000 s=f00000
Bootldr Partition: "bootldr", 0x00000000-0x00040000
Bootldr Partition: "params", 0x00040000-0x00080000
Bootldr Partition: "kernel", 0x00080000-0x00100000
Bootldr Partition: "root", 0x00100000-0x01000000
SA1100 flash access initialized
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind
2048)
Fast Floating Point Emulator V0.0 (c) Peter Teichmann.
devfs: v0.102 (20000622) Richard Gooch
(rgooch_at_atnf.csiro.au)
devfs: boot_options: 0x2
jffs2_scan_inode_node(): Data CRC failed on node at
0x0000ffc0: Read 0x5f2a6d32,
calculated 0xd8e55893
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 60K
Warning: unable to open an initial console.
Kernel panic: No init found. Try passing init= option
to kernel.
boot> set linuxargs "noinitrd root=/dev/mtdblock/3
init=/linuxrc console=ttySA0"
setting param=linuxargs to value=noinitrd
root=/dev/mtdblock/3 init=/linuxrc c
onsole=ttySA0
boot> set copy_ramdisk 0x0
setting param=copy_ramdisk to value=0x0
boot> set baudrate 115200
setting param=baudrate to value=115200
update_baudrate: new baudrate=0001C200
baudrate changed to 0x0001C200
boot> params save
bootldr: set linuxargs "noinitrd root=/dev/mtdblock/3
init=/linuxrc console=ttyS
A0"
programming flash...erasing ...
Erasing sector 00040000
writing flash..
addr: 00040000 data: 646C7470
verifying ... done.
boot> boot
booting flash...
kernel_magic=E1A00000
kernel_region_words[9]=016F2818
Linux ELF flash_imgstart=50080000 size=000C0000
dest=C0000000 offset=00008000
MMU Control=C19F4071
copying Linux kernel ... done
linuxEntryPoint: C0008000
kernel_image_dest: C0000000
kernel_image_offset: 00008000
C0008000: E1A00000
C0008004: E1A00000
C0008008: E1A00000
C000800C: E1A00000
C0008010: E1A00000
C0008014: E1A00000
C0008018: E1A00000
C000801C: E1A00000
C0008020: EA000002
C0008024: 016F2818
root_filesystem_name=ramdisk
argc=00000002
args=noinitrd root=/dev/mtdblock/3 init=/linuxrc
console=ttySA0
setting boot parameters
get_param: could not find parameter system_rev
Setting up Linux parameters at address=C0000100
using_ramdisk=00000001
initrd_start=346C7466
dram_size=02000000
nr_pages=00002000
command line is: noinitrd root=/dev/mtdblock/3
init=/linuxrc console=ttySA0
linuxEntryPoint=C0008000
Booting Linux image
Uncompressing
Linux....................................... done,
booting the ker
nel.
Linux version 2.4.3-rmk2-np1 (root_at_step) (gcc version
2.95.4 20010319 (Debian pr
erelease)) #2 Mon May 14 12:21:48 PDT 2001
Processor: Intel StrongARM-1110 revision 6
Architecture: Compaq iPAQ
On node 0 totalpages: 8192
zone(0): 8192 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: noinitrd root=/dev/mtdblock/3
init=/linuxrc console=ttySA0
Console: colour dummy device 80x30
Calibrating delay loop... 194.15 BogoMIPS
Memory: 32MB = 32MB total
Memory: 30872KB available (987K code, 256K data, 60K
init)
Dentry-cache hash table entries: 4096 (order: 3, 32768
bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096
bytes)
Page-cache hash table entries: 8192 (order: 3, 32768
bytes)
Inode-cache hash table entries: 2048 (order: 2, 16384
bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society
NET3.039
Starting kswapd v1.8
Console: switching to colour frame buffer device 40x30
pty: 256 Unix98 ptys configured
block: queued sectors max/low 20224kB/6741kB, 64 slots
per queue
JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by
Axis Communications AB.
SA1100 serial driver version 1.3
ttySA0 on SA1100 UART3 (irq 17)
ttySA1 on SA1100 UART1 (irq 15)
ttySA2 on SA1100 UART2 (irq 16), using IRDA
SA1100 flash: probing for 4 partitions (buswidth = 4)
SA1100: Found 2 x16 devices at 0x0 in 32-bit mode
JEDEC ID: 89 17
0: offset=0x0,size=0x40000,blocks=64
No RedBoot partition table found. Using default
partitioning
parse_bootldr_partitions:
partition_table_offset=0x40000
parse_bootldr_partitions: magic=0x646c7470
parse_bootldr_partitions: npartitions=0x4
partition bootldr o=0 s=40000
partition params o=40000 s=40000
partition kernel o=80000 s=80000
partition root o=100000 s=f00000
Bootldr Partition: "bootldr", 0x00000000-0x00040000
Bootldr Partition: "params", 0x00040000-0x00080000
Bootldr Partition: "kernel", 0x00080000-0x00100000
Bootldr Partition: "root", 0x00100000-0x01000000
SA1100 flash access initialized
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind
2048)
Fast Floating Point Emulator V0.0 (c) Peter Teichmann.
devfs: v0.102 (20000622) Richard Gooch
(rgooch_at_atnf.csiro.au)
devfs: boot_options: 0x2
jffs2_scan_inode_node(): Data CRC failed on node at
0x0000ffc0: Read 0x5f2a6d32,
calculated 0xd8e55893
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 60K
Warning: unable to open an initial console.
Kernel panic: No init found. Try passing init= option
to kernel.
end:
I double checked my args and re-downloaded and
installed the kernel but it still gives me the same
message... Any ideas?
Vielen dank!
Aaron
__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
Received on Thu Aug 30 2001 - 10:19:01 EDT
This archive was generated by hypermail 2.2.0 : Mon Jul 25 2005 - 17:12:34 EDT