Disconnecting the cable and changing settings at any time is fine.
Keep in mind that the bootldr settings need to match. And, Yes,
don't worry about protecting it before resetting, it apparently
does not work reliably. If the peek values look fine, you are
OK. Just be sure to protect it before doing anything else that
changes flash memory.
Ken
On Wed, 23 May 2001 16:18:15 -0700 (PDT)
Travis Newhouse <newhouse_at_cs.ucsd.edu> wrote:
>
> One more question: Is it alright to disconnect the serial cable
> before pushing the reset button on the bottom of the iPaq? Or, will
> this cause something bad to happen?
>
> I just noticed that the Windows Port Settings has the baud rate set to
> 57600 for the port I'm using (as opposed to 115200). I don't know if
> this has anything to do with the problems I'm encountering, but I
> would like to change it before continuing. Of course, only if it is
> safe to disconnect the serial cable before hitting reset.
>
> Thanks again,
> Travis
>
>
Received on Wed May 23 2001 - 16:22:54 EDT
This archive was generated by hypermail 2.2.0 : Mon Jul 25 2005 - 17:12:25 EDT