From: Jean Meloche (jmeloche@avaya.com)
Date: Thu Sep 13 2001 - 08:44:04 EDT
Hi!
I have installed the
Compaq OHH BootLoader, Rev 2-14-15 [BIG_KERNEL] [MONO]
on my iPAQ 3150 but it refuses to accept commands on the serial port.
I does report on the serial port as follows:
U3
@00000350
F0100BEEF
*MTST
00000001
00000002
00000004
00000008
00000010
00000020
00000040
00000080
00000100
00000200
00000400
00000800
00001000
00002000
00004000
00008000
00010000
00020000
00040000
00080000
00100000
00200000
00400000
00800000
01000000
02000000
04000000
08000000
10000000
20000000
40000000
80000000
ENDM
STKP
C19F3FFC
MMU table start=C19F4000
Boot data start=C19F8000
Boot data size=00008000
Stack data base=C19F0000
Stack data size=00004000
FLASH_BASE=00000000
Evacuating 1MB of Flash to DRAM at: C1E00000
done
Map Flash virtual section to DRAM at: C1E00000
machine is mitsy
verify flash size...
btflash_init: mfrid=00000089
devid=00000018
walking flash descriptors (1x16)
btflash_init: found flash 28F128J3A_1x16
flashDescriptor=000174A8
flashSectors=00017288
nsectors=00000080
flash_size=01000000
flash_address_mask=00FFFFFF
allocated partition_table
defining partiton: bootldr
defining partiton: params
defining partiton: kernel
dram_size: 01000000
>> Compaq OHH BootLoader, Rev 2-14-15 [BIG_KERNEL] [MONO]
>> Last link date: Mon Aug 20 15:15:01 PDT 2001
>> Contact: bootldr@handhelds.org
>> ARM Processor Rev=6901B116
>> (c) 2000 Compaq Cambridge Research Laboratory
Press Return to start the OS now, any other key for monitor menu
DEBUG BOOT: not evaluating params
DEBUG BOOT: use `params eval' to evaluate parameters.
What can I do?
Many thanks.
-- This message is intended only for the designated recipient(s). If you are not a designated recipient, you may not review, copy or distribute this message. If you receive this in error, please notify the sender by reply e-mail and delete this message. Thank you. jmeloche@avaya.com (908) 582-4894 Jean Meloche
This archive was generated by hypermail 2.1.5 : Fri Jan 17 2003 - 17:47:02 EST