Re: X51V: Can't calibrate on first boot

On 6/22/07, 0xd34df00d <0xd34df00d_at_gmail.com> wrote:
> For me the sequence is upper left->upper right->lower right->lower
> left->center. And I think that touching the screen several times to
> get the crosshair moving is not OK, am I right?
>
> And what do you mean by firmware reload? I'm using Haret.
>
> 2007/6/23, Robert Martin <robertltux_at_gmail.com>:
> > On 6/22/07, 0xd34df00d <0xd34df00d_at_gmail.com> wrote:
> > > Hi all!
> > >
> > > I've followed the manual exactly, but when I try to calibrate my
> > > screen (as prompted on first boot), I can't do it, because calibration
> > > becames an infinite loop (after I press the crosshair in the center of
> > > the screen, it moves back to it start position - top-left), so I can't
> > > go further. And by the way, to get crosshair moving to any next
> > > position, I should press (anywhere on the screen) five or six times.
> > >
> > > Thanks a lot and sorry for my English.
> > >
> > > --
> > > --
> > > _______________________________________________
> > > Aximx50-port mailing list
> > > Aximx50-port_at_handhelds.org
> > > https://www.handhelds.org/mailman/listinfo/aximx50-port
> > >
> > what it should do is center upper left upper right lower left lower
> > right > next the trick is you need to peg the crosshair in the center
> > each time (there may be some sort of checksum to prevent a bad
> > calibrate)
> > if that doesn't work i would suggest doing a firmware reload
> > --
> > Robert L Martin
> > --
>
a suggestion check to see if the axim works under the default os
(leave the card out and then try it) also please put your responses
below the previous postings

-- 
Robert L Martin