Re: X51V: Can't calibrate on first boot

For me the sequence is upper left->upper right->lower right->lower
left->center. And I think that touching the screen several times to
get the crosshair moving is not OK, am I right?

And what do you mean by firmware reload? I'm using Haret.

2007/6/23, Robert Martin <robertltux_at_gmail.com>:
> On 6/22/07, 0xd34df00d <0xd34df00d_at_gmail.com> wrote:
> > Hi all!
> >
> > I've followed the manual exactly, but when I try to calibrate my
> > screen (as prompted on first boot), I can't do it, because calibration
> > becames an infinite loop (after I press the crosshair in the center of
> > the screen, it moves back to it start position - top-left), so I can't
> > go further. And by the way, to get crosshair moving to any next
> > position, I should press (anywhere on the screen) five or six times.
> >
> > Thanks a lot and sorry for my English.
> >
> > --
> > --
> > _______________________________________________
> > Aximx50-port mailing list
> > Aximx50-port_at_handhelds.org
> > https://www.handhelds.org/mailman/listinfo/aximx50-port
> >
> what it should do is center upper left upper right lower left lower
> right > next the trick is you need to peg the crosshair in the center
> each time (there may be some sort of checksum to prevent a bad
> calibrate)
> if that doesn't work i would suggest doing a firmware reload
> --
> Robert L Martin
> --
> _______________________________________________
> Aximx50-port mailing list
> Aximx50-port_at_handhelds.org
> https://www.handhelds.org/mailman/listinfo/aximx50-port
>

--